CowCow Type 1 CNC Aluminum Trigger for TM Hi-Capa/1911 Pistols, Red

Stock triggers on Tokyo Marui Hi-Capa and 1911 GBB pistols work fine until you start chasing tighter groups or faster splits. The face sits at an awkward angle, the reset feels mushy, and you're carrying unnecessary weight in the slide. The CowCow Type 1 CNC Aluminum Trigger addresses these issues directly.

What changes with the swap. The flat face design puts your trigger finger on a consistent contact point shot to shot. That matters more than most people expect when running heavier trigger springs or tuning for competition. At 3 grams, it removes weight from the moving mass inside the slide. CNC aluminum holds its shape under repeated firing, unlike polymer stock parts that can deform over time.

Installation and fit. This drops into any Tokyo Marui Hi-Capa or 1911-pattern GBB using the standard trigger assembly. No machining, no fitting, just swap and go. The red anodized finish is cosmetic, but it makes the part easy to spot during dry-fire practice or maintenance.

What this isn't. This is a single component, not a complete trigger group. You're replacing the trigger leaf only, so expectations should match that scope. If your goal is a full trigger job with adjusted pull weight and overtravel stops, you'll need additional parts beyond this.

Includes the trigger only. Installation tools and additional components sold separately.