Atlas Custom Works Module Trigger Type-1 Shoe A for TM Hi Capa Series, Black

If you're running a TM Hi Capa and the stock trigger shoe feels too narrow or slick under pressure, the Atlas Custom Works Module Trigger Type-1 Shoe A swaps in a wider, more contoured surface that gives your finger a better anchor. It's machined from aluminum, so it won't wear down the way polymer can after hundreds of dry-fires or match days. The Type-1 profile is a modest upgrade in reach and surface area, not a complete ergonomic overhaul—think of it as fine-tuning what's already there.

What you get. Just the trigger shoe. No tools, no instructions, and it's designed for the TM-spec Hi Capa platform specifically. If your pistol is a clone or aftermarket variant, fit isn't guaranteed even if it looks like a Hi Capa. The black finish is bare aluminum, so it may show wear over time but won't chip or peel like painted surfaces.

Installation. This replaces the factory shoe by removing the trigger group and swapping the component. If you're not comfortable disassembling your pistol's trigger assembly, budget for a gunsmith visit or do it at home before your first match. Once it's on, it stays on until you decide to change it again.

This is a fit-and-finish part, not a performance upgrade. It won't change your trigger pull weight, reset, or FPS. It's for players who want a more comfortable grip angle or a wider surface to press against during rapid fire.