Code 11 AXON Pro Single Wire Switch (Single Key), Black

Your support hand is already on the forend. The AXON Pro puts a laser or light control right where your finger naturally rests, so you don't have to reach back and fumble with a device mounted behind the carry handle.

How it works. One button, one wire, one device. Press it once to turn your laser or light on, press it again to turn it off. No momentary hold, no confusing mode cycles. It's a straightforward constant-on toggle, which is simpler for players new to switches and less likely to accidentally leave a laser burning during a reload.

One device, not two. The single-wire design controls a single output. If you want a laser and a light on separate triggers, you'd run two single-key switches or go dual-wire. For a laser-only build, or a light-only setup where you want independent control, this is the clean option. The single cable also means one fewer wire to route along the rail.

It comes ready for whatever you're mounting. The kit includes adapter connectors for the three most common formats: 2.5mm (standard for most laser modules and flashlights), Crane Laser (common on PEQ-style devices), and SF adapters. You're also getting both a Picatinny rail mount and an M-LOK bracket, plus the mounting hardware and a hex key. You can install it today without ordering extras.

Before you buy. Check your device's connector type against what's in the kit. If you're running a proprietary adapter or an older laser module, you may need a separate connector. Wire length is set at the factory, so position the switch on the rail with the cable reaching your device with a little slack, not stretched tight. Nylon housing keeps weight to roughly 0.13 lbs, which is basically nothing on a rail.